diff --git a/codetestingplayground/trace-teardrops.circuit.tsx b/codetestingplayground/trace-teardrops.circuit.tsx
new file mode 100644
index 00000000..bd0e2462
--- /dev/null
+++ b/codetestingplayground/trace-teardrops.circuit.tsx
@@ -0,0 +1,14 @@
+export default () => (
+  <board width="16mm" height="10mm">
+    <resistor name="R1" resistance="100" footprint="0603" pcbX={-3} />
+    <capacitor name="C1" capacitance="10nF" footprint="0603" pcbX={3} />
+    <trace
+      from="R1.2"
+      to="C1.1"
+      thickness="0.2mm"
+      pcbPath={[]}
+      pcbTeardrops
+      pcbTeardropEnd={false}
+    />
+  </board>
+)
diff --git a/docs/elements/trace.mdx b/docs/elements/trace.mdx
index b48c01c6..0c2083ac 100644
--- a/docs/elements/trace.mdx
+++ b/docs/elements/trace.mdx
@@ -41,8 +41,36 @@ Here's a simple example connecting two components:
 | `width` | Width of the trace (optional) | `"0.2mm"` |
 | `thickness` | Same as `width`; sets the copper width for the trace (optional) | `"0.2mm"` |
 | `pcbPath` | Array of points defining a manual PCB path relative to an anchor port | `[{ x: 1, y: 0 }, { x: 1, y: 1 }]` |
+| `pcbTeardrops` | Enable automatic PCB teardrops | `true` |
+| `pcbTeardropStart` | Teardrop at the start (from) of trace | `true` |
+| `pcbTeardropEnd` | Teardrop at the end (to) of trace | `false` |
 | `pcbPathRelativeTo` | Port selector that `pcbPath` coordinates are relative to (defaults to the `from` port) | `".R1 > .pin2"` |
 
+## PCB teardrops
+
+Set `pcbTeardrops` to widen traces at pad and via contacts after routing.
+Use `pcbTeardropStart` and `pcbTeardropEnd` to override the `from` and `to`
+endpoints. Omitted endpoint settings inherit `pcbTeardrops`.
+
+This example adds a teardrop at R1 while leaving the C1 end unchanged:
+
+<CircuitPreview defaultView="pcb" code={`
+export default () => (
+  <board width="16mm" height="10mm">
+    <resistor name="R1" resistance="100" footprint="0603" pcbX={-3} />
+    <capacitor name="C1" capacitance="10nF" footprint="0603" pcbX={3} />
+    <trace
+      from="R1.2"
+      to="C1.1"
+      thickness="0.2mm"
+      pcbPath={[]}
+      pcbTeardrops
+      pcbTeardropEnd={false}
+    />
+  </board>
+)
+`} />
+
 ## Connecting to Nets
 
 Traces can connect to named nets like power and ground: